I had a GoPro mounted between the seats a while back. Unfortunately, years back I removed all youtube videos after seeing other people getting busted for doing stupid stuff. Handles great. It's not...
Type: Posts; User: marcair
I had a GoPro mounted between the seats a while back. Unfortunately, years back I removed all youtube videos after seeing other people getting busted for doing stupid stuff. Handles great. It's not...
ENGINE: 2003 Hayabusa (rebuilt July 2017 to 1550cc by Downs Engineering) mid-engine mounted. 2nd generation crank, low compression ceramic coated pistons, remote oil filter, Tilton electric oil pump...
Don't know if this is helpful, but I just replaced my pads and attached is a pic of the part numbers. These were bought 11 years ago as part of a large cache of spares when I first bought the Beat. I...
regarding the two screws, I loosened the one screw retaining the square section of the clip and the clip easily popped out.2732
Last year I bought some new MFR parts from a Member here that communicate with Japan. Are you still here?
Can anybody source/obtain new bushings for the entire rear suspension. Would greatly appreciated.
At next spray job want to replace the fiberglass side skirts. Can you offer sources. Apologies for the flipped pic.
Can anyone offer documentation for pp11016872 for submission to motor vehicle dept. Have concern about true build year.
Thanks all. The new owner has been sent this site address.
On behalf of new owner in US, looking to source total rebuild kit. All comments welcome. Motor tired and burns oil.
Is it safe to say that these items are unique to the Beat and not used on other exported models?
Can anyone post the part numbers for future reference. Looking for the rubber ends. And are the parts same as another honda model? Just adding to database. Thanks.
269026882689
Installed a direct electronics solenoid assy, fab'd a pop-up spring assy. will install switch above fuel door release in door jam. Total is less than $30
I'm shopping for a small solenoid activated from inside the car. And include a spring.
Last summer increased motor from 1300cc to 1550cc. Adding paddles this spring
Anybody installed a power trunk release? Seems a other Honda model assy may be adapted. Thoughts.
Consider fabricating a new assy. I did so. Raw stock of 1 inch and 5/8 inch thin wall tubing with minor welding of the clips is simple.
My beat has been on the street in socal for 10 years. Pm me for spares and knowledgeable maintenance support info. A guy in the valley imports cars and parts. There are several Japanese car shows...
Just converted my system to 134 with no issues. Replaced the dryer
Had same symptoms years ago. Bearings were worn. Simple fix.
Where is the Beat? Country?
Pro job. Consider adding slots to adjust camber. Probably too late..
Now that the top is more rigid. Consider fab an h for the bottom.
Thanks to Mr Hughes for the replacement parts all is well. After installing and closing the trunk I noticed the latch did not work. The fire melted the plastic clip. Fortunately a have large vents...
Steve, see my earlier attached pic of the fan and condenser relays. Are we saying the same with different terms or are there 2 different configurations
Re. The Ecu location: check out second skin thermal barrier in Arizona. I bought a variety of materials for heat and sound. When I did the engine swap I lined the engine compartment with thermal and...