Honda Beat Workshop Manual

[soongster]

I do wonder if there would be any demand for the whole thing in English?

1 here

pretty sure there's demand for it.

got a few people asking on the FB groups for an English version. haha

[stu g]

OK, so here is page 4 -8. Sorry that the tables don't paste in well. You might have to cut and paste them out in to Excel.

Engine Manual 4 – 8 Metal selection, mating
Main bearing
Caution
• If you hare changing the main bearing, look up the crankshaft bearing mating mark and the cylinder block hole mating mark against the table.
• When you have inserted the new bearing, measure the oil clearance.

Cylinder block image - No1 journal, No4 journal
Translator’s note (the first letter “C” is the No 1 journal, second is No2 journal etc)

Cylinder block hole (44mm)
Mating mark Data
No2 and No3 journal No 1 and No4 journal
A +0.000mm to +0.006mm -0.006mm to +0.000mm
B +0.006mm to +0.012mm +0.000mm to +0.006mm
C +0.012mm to +0.018mm +0.006mm to +0.012mm
D +0.018mm to + 0.024mm +0.012mm to +0.018mm

Crankshaft image – Crankshaft journal mating mark stamp
No1 journal, No 4 journal
Translator’s note (the first number “2” is the No 1 journal, second is No2 journal etc)

Shell bearing image (right hand side of page) – align the notch in the correct place. Note the colour mark on the side of the shell.
Selection table
Bearing thickness is 2mm
Mark Colour mark Data
G Red 0.000mm to -0.003mm
F Pink +0.003mm to 0.000mm
E Yellow +0.006mm to +0.003mm
D Green +0.009mm to + +0.006mm
C Brown +0.012mm to +0.009mm
B Black +0.015mm to +0.012mm
A Blue +0.018mm to +0.015mm

Each bearing colour goes up in 0.003mm increments.
Main bearing mating table
Crankshaft journal mating mark Cylinder block hole mating mark
A B C D
Bearing side colour
1 Red Pink Yellow Green
2 Pink Yellow Green Brown
3 Yellow Green Brown Black
4 Green Brown Black Blue

It might be expected that the housing may have expanded following any incident.
These are set up so that, as before, No1 journal is 0.016mm to 0.032mm, and No2 and No3 journals are 0.020mm to 0.028mm.
Caution: Don’t just rely upon this table, ensure that you measure the oil clearance again afterwards.